Alcatel-Lucent OmniAccess 780 User Manual

Starting the OmniAccess 780
Left running head:
Chapter name (automatic)
62
Beta Beta
OmniAccess 780 Hardware Users Guide
Alcatel-Lucent
Step 4: From SUM, you can enter the Configuration Mode (CM). The CM is used
to configure the system globally, to enter specific configuration modes, or to
configure specific elements, such as interfaces or protocols.
Enter the configure terminal command to enter the Configuration mode.
Example:
ALU# configure terminal
ALU(config)#
The above steps are enough to configure the OA-780 via console.
Step 5: To configure the system remotely (Telnet, SSH, and Modem), you need to
configure basic Authentication, Authorization, and Accounting (AAA)
configuration. AAA is a system in IP-based networking to control which users
have access to the system, what resources users have access to, and to keep
track of the activity of users over a network.
To enable the AAA services on your system, enter the aaa services command in
Configuration mode.
Example:
ALU(config)# aaa services
Step 6: Set the enable password (system password). To set the system
password, enter the following command:
enable {secret|password} [5] <password>
Example:
ALU(config)# enable secret test
Secret for level 15 is set
Note: By default, only the console session is available without the enable password
configuration.

Alcatel-Lucent OmniAccess 780 Specifications

General

Brand	Alcatel-Lucent
Model	OmniAccess 780
Category	Gateway
Language	English