Alcatel Router User Manual

# Running H/F 2
Router User Guide
configure router ospf interface network
This command configures the OSPF network type on an interface.
parameter definition
syntax:
[ no ] network < broadcast | non_broadcast | point_to_multipoint | point_to_point >
NOTE: If the interface type is point-to-point, then to change the network type to broadcast, the user must
first change the point-to-point interface to broadcast type using the ip address command.
NOTE: The “non_broadcast” and “point_to_multipoint” parameters are not supported in this release.
example:
Alcatel-host/configure/router/ospf/interface toBoston> network non_broadcast
related commands
applicable systems:
All models.
interface type network type default
PPP/HDLC point-to-point
Ethernet broadcast
Frame Relay point-to-point
network type
broadcast
Configures network type to broadcast multi-access network
non_broadcast
Configures network type to nonbroadcast multiaccess (NBMA) network
point_to_multipoint
Configures network type to point-to-multipoint network
point_to_point
Configures network type to point-to-point network
configure router ospf interface authentication
configure router ospf interface cost
configure router ospf interface dead_interval
configure router ospf interface hello_interval
configure router ospf interface neighbor
configure router ospf interface poll_interval
configure router ospf interface priority
configure router ospf interface retransmit_interval
configure router ospf interface transmit_delay

Alcatel Router Specifications

General

Brand	Alcatel
Model	Router
Category	Network Router
Language	English