Alcatel Router - Configure Router Ospf Interface Retransmit_Interval

Running H/F 2 #
Router User Guide
configure router ospf interface retransmit_interval
This command configures the retransmit time for the link state advertisement retransmission for
neighbors belonging to the interface.
When a router sends a link state advertisement to its neighbor, it keeps the LSA until it receives an
acknowledgment. If an acknowledgment is not received in n seconds, the router will retransmit the
LSA.
parameter definition
syntax:
[ no ] retransmit_interval < n >
example:
Alcatel-host/configure/router/ospf/interface toBoston> retransmit_interval 60
related commands
applicable systems:
All models.
seconds Time in seconds between retransmission.
It must be conservatively set, but greater than the expected round trip delay between
routers on the attached network.
The range is 1- 65535; the default is 5.
configure router ospf interface authentication
configure router ospf interface cost
configure router ospf interface dead_interval
configure router ospf interface hello_interval
configure router ospf interface neighbor
configure router ospf interface network
configure router ospf interface poll_interval
configure router ospf interface priority
configure router ospf interface transmit_delay