Alcatel Router - Page 229

Chapter : Multicasting 221
Router User Guide
IGMP Commands The IGMP commands supported in version 8.0 and higher are:
Enabling igmp /configure > ip igmp
Disabling igmp /configure > no ip igmp
Enabling igmp /configure/ip/igmp> interface <interface-name>[: dlci-no]
Disabling igmp /configure/ip/igmp> no interface <interface-name>
Configuring version /configure/ip/igmp/interface ethernet0> v er si o n < v e r si on >
Configuring Query
Interval
/configure/ip/igmp/interface ethernet0> query-interval
<interval>
Configuring Maximum
Response Time
/configure/ip/igmp/interface ethernet0>
query-response-interval <interval>
Configuring Last Member
Query Interval
/configure/ip/igmp/interface ethernet0>
last-member-query-interval <interval>
Configuring Last Member
Query Count
/configure/ip/igmp/interface ethernet0>
last-member-query-count <value>
Configuring Startup
Query Interval
/configure/ip/igmp/interface ethernet0> startup-query-interval
<interval>
Configuring Startup
Query Count
/configure/ip/igmp/interface ethernet0> startup-query-count
<count>
Configuring Robustness /configure/ip/igmp/interface ethernet0> robustness <value>
Configuring
Ignore-v1-message
/configure/ip/igmp/interface ethernet0> [no]
ignore-v1-messages
Configuring
Ignore-v2-message
/configure/ip/igmp/interface ethernet0> [no]
ignore-v2-messages
Configuring Send Router
Alerts
/configure/ip/igmp/interface ethernet0> [no] send-router-alert
Configuring Require
Router Alerts
/configure/ip/igmp/interface ethernet0> [no]
require-router-alert
Assigning filter list for
group filtering
/configure/ip/igmp/interface ethernet0> group-filter
<filter-list-name>
Debug Command
Enable all debug levels /debug> [no] ip igmp all
Debug state related
events
/debug> [no] ip igmp state
Debug normal events /debug> [no] ip igmp normal
Debug query packets /debug> [no] ip igmp packet query [inbound | outbound]
Debug report packets /debug> [no] ip igmp packet report [inbound | outbound]
Debug leave packets /debug> [no] ip igmp packet leave [inbound | outbound]
Show Commands