©2019 ALL-TEST Pro, LLC All Rights Reserved 16 Rev 06/20/2019
Reset the instrument
Simultaneously press the left and right arrow keys and then release. This performs a forced
hardware & firmware reset and will return the display back to the main menu
Automatic OFF
Without any operation, the instrument will turn off after idling for approximately 5 minutes.
However, if the instrument is set in Communication mode, the feature is disabled. If left
unattended, eventually the instrument battery will drain out completely.
To exit the communication mode:
1. If the MCA software on a computer perform any operation, e.g. upload data, download
data, upload route etc., the instrument will be discharged once the operation is
completed.
2. To manual is to use Left arrow and Right arrow simultaneously to reset the instrument.
See Section
To Next Page
