ALL-TEST PRO 7 - Viewing Results Upon Test Completion

ALL-TEST PRO 7™ User Manual
©2019 ALL-TEST Pro, LLC All Rights Reserved 28 Rev 06/20/2019
Rotation Speed Guidelines
Start by turning the Rotor slowly and as smoothly as possible in the same direction using a shaft
strap.
Maximum recommended rotor shaft rotational speed for 2 & 4-pole motors = 15 RPM
Maximum recommended rotor shaft rotational speed for 6-pole motors or higher = 7.5 RPM
Viewing Results Upon Test Completion
After the STATIC and DYNAMIC tests are done, the instrument will automatically analyze,
calculate and display the result menu screen, reporting OK, WARN, BAD or NoR = No Reading.
The following is summary of the alarms on different parameters:
RESISTANCE deviation
Displayed Result
< 3 %
OK
≥ 3% < 5 %
WARN
≥ 5 %
BAD
No Reading
NoR
STATOR signature dev
Displayed Result
< 1.1%
OK
≥ 1.1% < 3 %
WARN
≥ 3 %
BAD
Only STATIC test done
use REF (TVS)
Concentric Windings
CC
ROTOR signature dev.
Displayed Result
< 10 %
OK
≥ 10 % < 15 %
WARN
≥ 15 %
BAD
Only STATIC test done
use REF (TVS)
Small Signature Variation
With < 2 % variation
< 2
Note: Rotor analysis is a proprietary patented method
INSULATION MΩ
Displayed Result
≥ 100 MΩ
OK
≥ 5 MΩ < 100 MΩ
WARN
< 5 MΩ
BAD
No Reading
NoR