1 Publication 1734-UM002C-EN-P - July 2003
Preface
Purpose of this Manual
This manual describes how to install, configure and operate your
POINT I/O DeviceNet™ Adapter, catalog number 1734-ADN.
Who Should Use
This Manual
You must be able to use RSNetWorx™ for DeviceNet software or
similar configuration software to configure your adapter.
In this manual, we assume you know how to configure an adapter. If
you do not, refer to your software user manuals or online help before
attempting to use this adapter.
We also assume you are familiar with the POINT I/O product line,
including other fieldbus interfaces, I/O modules and power supplies.
If you are not familiar with these components, you can read some of
the POINT I/O documents listed on page
Preface-5.
For more information about: See page:
Who Should Use This Manual Preface-1
What the Manual Contains Preface-2
Related Terms Preface-3
Related Products and Documentation Preface-5
Guidelines for Using Your Adapter Preface-5
Conventions Used in This Manual Preface-6
IMPORTANT
In this manual, we use 1734-ADN(X) to refer to both
the 1734-ADN and 1734-ADNX modules. We use
1734-ADN to refer to only the 1734-ADN module. We
use 1734-ADNX to refer to only the 1734-ADNX
module.
In the rest of this manual (except Chapter 4), we
refer to the 1734-ADN(X) POINT I/O DeviceNet
adapter as the adapter.
In Chapter 4, we refer to the POINT I/O DeviceNet
adapter as the scanner because the chapter describes
how to configure the adapter for use with POINT
I/O modules.
To Next Page
Loading...
Need help?
General
