Publication 1756-UM514B-EN-P - February 2003
Using RSLogix 5000 in Remote I/O and Block Transfer Applications 9-21
8. To create a Block Transfer Write message, change the message
configuration as shown below.
9. Set the communication path for the message instruction.
A. Choose the Message Type
from the pull-down list.
B. Specify the Source
Element. You can:
· Choose an element from
the pull-down (i.e.
browse to the tag)
or
· Use the New Tag button to
create the tag where
data is written to on the
remote module.
C. Type the Number of
Elements being written.
If you create a New Tag, you must:
A. Name the tag.
B. Make sure the Data Type
is Integer (INT).
A. Use the Browse button to
choose the path.
B. Choose the destination
module for the message
instruction.
C. Click on OK.
To Next Page
Loading...
