Allen-Bradley 1756-DHRIO - Set the Module Switches; Set-Up a Routing Table for the 1756-DHRIO Module

Publication 1756-UM514B-EN-P - February 2003
Messaging Between PLC-5s and SLC-5/04s 4-13
Set the Module Switches
In this application, you must set switches on the 1756-DHRIO module
for DH+ and the switches on the 1756-CNB module to Node
address
22.
For more information on setting switches on the 1756-DHRIO module,
see
page 1-5. For more information on setting the switches on the
1756-CNB module, see page 4-9.
Set-Up a Routing Table for the 1756-DHRIO Module
Use RSLinx to set-up a routing table for the 1756-DHRIO module.
Figure 4.13 shows the routing table for this example.
Figure 4.13
1
2