Publication 1756-UM514B-EN-P - February 2003
3-12 Using Programming Software in DH+ Applications
Using RSLogix 500
RSLogix 500 is required to send read/write message instructions from
SLC-500s in DH+ applications. To send messages, follow these steps:
1. Start the RSLogix 500 software.
2. Begin a new project or open an existing project.
3. Add a rung to the ladder logic portion of the project.
4. Add a message instruction (MSG) to the new rung.
IMPORTANT
This section offers a brief description of how to send
a message via RSLogix 500. For a full description of
how to use the software, see the online help.
Click here to
add a rung.
Click here to
add a MSG.
To Next Page
Loading...
