Publication 1756-UM514B-EN-P - February 2003
Using Programming Software in DH+ Applications 3-7
6. To assign a Link ID for the chassis backplane, follow the
procedure described in
step 5. When you are finished assigning
Link IDs, your screen should look similar to the one below.
The software prompts you to download routing table changes.
When the routing table is downloaded, RSLinx returns to the
Browsing screen. This completes the routing table creation process.
Setting the Controller Slot
The Controller Slot is the physical location of a ControlLogix controller
in a DH+ application. The default setting is slot 0. If necessary, use the
Channel Configuration tab to change the Controller Slot number.
Click on OK.
Click on OK.
A. Change the
Controller slot.
B. Click on OK.
To Next Page
Loading...
