Publication 1756-UM514B-EN-P - February 2003
Messaging Between PLC-5s or SLC5/04s and ControlLogix Controllers 5-11
Configure Message Instructions
Use RSLogix 500 to configure the SLC-500 message instructions.
Figure 5.11 shows a message instruction necessary for this example.
Figure 5.11
For more information on how to configure message instructions using
the RSLogix 500 software, see
page 3-9 or the RSLogix 500 online
help.
Chapter Summary and
What’s Next
In this chapter, you read about Messaging Between PLC-5s or
SLC5/04s and ControlLogix Controllers.
Chapter 6 describes Messaging
Between ControlLogix Controllers and PLC-5s or SLC-5/04s.
IMPORTANT
RSLogix 500 displays nodes and link IDs in decimal.
Also, in this application, a remote bridge address is
not required.
3
See PLC-5 Instruction Set
Reference, publication 1785-6.1
To Next Page
Loading...
