Allen-Bradley 1756-DHRIO - Using Programming Software in DH+ Applications; Choosing the Correct Software

1 Publication 1756-UM514B-EN-P - February 2003
Chapter 3
Using Programming Software in
DH+
Applications
Using This Chapter
This chapter describes how to use programming software with your
1756-DHRIO module in DH+ applications, including a brief discussion
of how to use each. For more information on these software, see the
online help in each.
Choosing the Correct
Software
The programming software you need is dependent on what products
you are using with the 1756-DHRIO module.
Table 3.1 explains what
software is needed for your application.
For information about: See page
Using RSLinx to Create a Routing Table 3-2
Using RSLinx Software to Send Control and
Information Protocol Messages
3-8
Using RSLogix 5 3-9
Using RSLogix 500 3-12
Using RSLogix 5000 3-15
Defining Connection Paths 3-20
Connection path examples 3-21
Table 3.1
Software Needed for 1756-DHRIO Applications
If you are using this product with the
1756-DHRIO module to read/write
data in a DH+ application:
You must use this software:
PLCs RSLinx
RSLogix 5
SLCs RSLinx
RSLogix500
ControlLogix Controllers RSLinx
RSLogix 5000