Publication 1756-UM514B-EN-P - February 2003
Messaging Between PLC-5s and SLC-5/04s 4-7
Configure Message Instructions
Use RSLogix 500 to configure the SLC-500 message instructions.
Figure 4.6 shows a message instruction for this example.
Figure 4.6
For more information on how to configure message instructions using
the RSLogix 500 software, see
page 3-12 or the RSLogix 500 online
help.
IMPORTANT
RSLogix 500 displays Nodes and link IDs in decimal.
Also, in this application, a remote bridge address is
not required.
3
See SLC-500 Instruction Set
Reference, publication 1747-6.15
To Next Page
Loading...
