1 Publication 2707-UM005AB-EN-P
Chapter
3
Initial Setup and Mode Menu
Objectives
This chapter describes how to apply power to and then configure the
MicroView using the menu keys. Instructions on how to use the
Simulate mode to run an application are also provided. This chapter
contains the following sections:
Section Page
Applying Power 3-2
Powerup Sequence 3-3
Mode Menu 3-4
Resetting the MicroView 3-5
Setting Communication Parameters Manually 3-5
Special Functions for Controller Operations 3-6
Entering a New Master Security Code 3-7
Enabling or Disabling Scaling 3-8
Using Simulate Mode 3-9
Test Functions 3-11
To Next Page
Loading...
