Allen-Bradley 2707-MVP232 - Using the Clear Fault Function

Publication 2707-UM005B-EN-P
C-12 MicroView Special Controller Functions
Using the Clear Fault
Function
Use the Clear Fault function to clear all major and minor faults in the
logic controller.
To clear controller faults:
1. Press [4] Clr Flt from the Special Menu to access the Clear Fault
function.
You are prompted to clear faults:
2. Press [1] to clear the faults or [0] to abort the function.
The faults are cleared and you are returned to the special
functions menu:
IMPORTANT
The MicroLogix controller must be in the Program or
Remote Program mode. Faults can not be cleared if
the controller is in the Run mode.
1 P-A/D
2 Mode
3 Prgrm
4 Clr Flt
1 = Clear Fault
2 = Abort
1 P-A/D
2 Mode
3 Prgrm
4 Clr Flt