Publication 2707-UM005B-EN-P
C-10 MicroView Special Controller Functions
Using the Mode Function
Use the Mode function to change the controller operating mode (Run
or Program) from the MicroView. The mode function display is shown
below:
1. Press [2] Mode from the Special Menu to access the Mode
function.
2. Depending upon the current mode, you are prompted to change
the controller mode:
3. Press [1] or [0] to enter your selection.
You are returned to the Main Menu.
If the controller is in Run mode: If the controller is in Program mode:
PLC Mode = RUN
1=Prog
0=Abort
PLC Mode = PROG
1=Prog
0=Abort
To Next Page
Loading...
Need help?
General
