Rockwell Automation Publication IASIMP-QS035B-EN-P - April 2015 33
Chapter 2
Add a Kinetix 5500 Drive to a Logix Designer Application
In this chapter, you add the Kinetix 5500 servo drive to your Logix Designer application project, download the project to
the Logix5000 controller, and verify communication between drive and motor by applying power and testing an axis.
Before You Begin
Complete wiring the connector plugs, connecting the Ethernet cables, and configuring the IP address for your
Kinetix 5500 drive (refer to Chapter
1).
What You Need
• Logix Designer application, version 21.00 or later
• The Kinetix 5500 Servo Drives User Manual, publication 2198-UM001
To Next Page
Loading...
Need help?
General
