Allen-Bradley Rockwell Automation 1734-AENT - Page 40

Publication 1734-UM011D-EN-P - May 2011
24 Configure the Adapter for Your EtherNet/IP Network
To configure the adapter with a fixed IP address, seeConfigure the Adapter
with Fixed IP Address on page43.
ATTENTION
To avoid unintended control, the 1734-AENT adapter must be
assigned a fixed IP address. The IP address of this adapter
should not be dynamically provided. If a DHCP server is used, it
must be configured to assign a fixed IP address for your adapter.
Failure to observe this precaution may result in unintended
machine motion or loss of process control.