Allen-Bradley SLC 500 Series - Page 684

Publication 1747-RM001G-EN-P - November 2008
2 Index
configuring SLC 5/05 13-31–13-34
using the Rockwell Utility 13-33
Broadcast write command 13-6
C
capturing M0-M1 file data E-24
carry bit B-5
channel 0
modem lost
B-24
SLC 5/03, 5/04, and 5/05 full-duplex
station
13-50, 13-51, 13-79
SLC 5/03, 5/04, and 5/05 remote station
13-66, 13-71
channel configuration
Modbus RTU Master parameters
13-93
channel-to-channel passthru 14-2
Clear (CLR) 4-12
math instruction 4-12
clock/calendar day B-54
clock/calendar hours B-54
clock/calendar minutes B-54
clock/calendar month B-53
clock/calendar seconds B-54
clock/calendar year B-53
common interface file addressing mode
B-15
common techniques used in this manual
P-2
communication
configuring SLC 5/03, 5/04, and 5/05
full-duplex station
13-50,
13-51, 13-79
configuring SLC 5/03, 5/04, and 5/05
remote station
13-66, 13-71
communication information
Data Highway Plus communication
protocol
13-10
RS-232 communication protocol (DF1)
full-duplex
13-49
half-duplex DF1 master/slave proto-
col
13-55
half-duplex DF1 slave protocol
13-55
communication instructions 12-1
ControlNet Explicit Message (CEM)
12-45
DeviceNet Explicit Message (DEM)
12-52
error codes 12-41
EtherNet/IP Explicit Message (EEM)
12-58
message instruction (5/02 only) 12-5
message instruction (SLC 5/03 and SLC
5/04)
configuration options
12-11
control block layout 12-30
entering parameters 12-11
timing diagram 12-37
Service Communications (SVC) 12-3
communication rate
SLC 5/03, 5/04, and 5/05
13-51, 13-58,
13-66, 13-71, 13-79
communications active (channel 0) B-47
communications active bit B-7
communications servicing selection
(channel 0)
B-47
comparison instructions 3-1
about 3-1
Not Equal (NEQ) 3-2
Compute (CPT) 4-25
math instruction 4-25
configuring
Minimum DF1 Half-Duplex Master
13-61
Minimum Master ACK Timeout 13-62
SLC 5/03, 5/04, and 5/05 13-64
control file 1-5, E-3
control instructions 6-1
control line
SLC 5/03, 5/04, and 5/05
13-51, 13-58,
13-66, 13-71, 13-80
control register error bit B-22
ControlNet Explicit Message (CEM)
12-45
Convert to BCD (TOD) 5-2
data handling instruction 5-2
Copy File (COP)
using
5-13
Cosine (COS) 4-30
math instruction 4-30
Count Down (CTD)
using status bits
2-15
Count Up (CTU) 2-13, 2-14
counter instruction 2-14
using status bits 2-14
counter accumulator value (.ACC) 1-7
counter file E-3
counter instructions
addressing structure
1-7
counter preset value (.PRE) 1-7
counters
addressing counters
1-7
Count Up (CTU) 2-14