Default Cycle Time
The cycles listed are the default cycle times programmed in at the
factory (default cycle is Normal 40). This cycle can be made lon-
ger or shorter by reprogramming the fill/agitate times. Refer to
Programmable Options to change these times. All other times are
not programmable.
Description Step Number Step Type
Step Time (Minutes:Sec-
onds)
Initial Drain 1 Extract 0:10
Prewash (Active with Mod1
only and using wetting fill)
2 Fill 2:30
3 Supply 0:30
4 Agitate 1:30
5 Cooldown -
6 Extract 2:00
Wash (Using wetting fill)
7 Fill 2:30
8 Supply 0:30
9 Agitate Normal = 6:00
Perm Press and Delicate =
3:00
10 Cooldown -
11 Extract Normal and Perm Press =
4:20
Delicate = 4:05
Rinse 1
12 Fill 2:00
13 Agitate 0:35
14 Extract Normal and Perm Press =
4:20
Delicate = 4:05
Rinse 2 (Active with Mod2
only)
15 Fill 2:00
16 Agitate 0:35
17 Extract Normal and Perm Press =
4:20
Delicate = 4:05
Table continues...
Default Cycle Time
©
Published by permission of the copyright owner -
DO NOT COPY or TRANSMIT
121 Part No. 805405ENR5
To Next Page
Loading...
