Special Vend 1 is used to change the standard vend prices for spe-
cial occasions. The special vend can be programmed to start and
end on a specific day or days of the week.
The owner may also turn the Special Vend 1 option on or off if
desired.
1. Control must be in Manual Mode. Refer to How to Enter the
Manual Mode.
2. Press the NORMAL 40 (∧) or the DELICATES COLD (∨)
keypad until Prog appears in the display. Press the START
(enter) keypad, and AtS 1 will appear in the display.
3. Press the NORMAL 40 (∧) or the DELICATES COLD (∨)
keypad to scroll through the programmable options until
SP1- appears in the display. Press the START (enter) keypad
and SP1 1 will appear in the display.
4.
When SP1 1 appears in the display, press the START (enter)
keypad. A number will appear in the display that corresponds
to the current Special Vend 1 Days Enable Programming Val-
ue.
5. Locate the desired number in the first column of Table 8 .
6. Press the NORMAL 40 (∧) or the DELICATES COLD (∨)
keypad to increase or decrease the current number until cor-
rect.
7. Press the START (enter) keypad when the correct value ap-
pears in the display. The new value is saved and the next op-
tion will appear in the display.
How to Read the Days Enable Value Table
To determine the correct number required to program the Special
Vend Days Enable, Water Leak Detection Days of Week Enable
or the Lucky Cycle Day(s) of Week / Enable, use the following
table. The Value column contains the number required in step 6.
The other columns correspond to individual days.
Each column of days contains a unique combination of the words
“ON” and “OFF” that indicates if that column’s day is turned on
or off when the value is entered. Select the desired combination
of days and enter the number found in the value column.
SP1 1, E Ld 1 and LUC 1
VALUE SAT FRI THUR WED TUE MON SUN ON/OFF
0* OFF OFF OFF OFF OFF OFF OFF OFF
3 OFF OFF OFF OFF OFF OFF ON ON
5 OFF OFF OFF OFF OFF ON OFF ON
7 OFF OFF OFF OFF OFF ON ON ON
9 OFF OFF OFF OFF ON OFF OFF ON
11 OFF OFF OFF OFF ON OFF ON ON
13 OFF OFF OFF OFF ON ON OFF ON
15 OFF OFF OFF OFF ON ON ON ON
17 OFF OFF OFF ON OFF OFF OFF ON
19 OFF OFF OFF ON OFF OFF ON ON
21 OFF OFF OFF ON OFF ON OFF ON
23 OFF OFF OFF ON OFF ON ON ON
25 OFF OFF OFF ON ON OFF OFF ON
27 OFF OFF OFF ON ON OFF ON ON
29 OFF OFF OFF ON ON ON OFF ON
31 OFF OFF OFF ON ON ON ON ON
Table 8 continues...
Programming Control
©
Published by permission of the copyright owner -
DO NOT COPY or TRANSMIT
59 Part No. 805405ENR5
To Next Page
Loading...
