Network Node Number nodE
This option allows the owner to program a unique number used
for wired or wireless communication. Every machine on the same
network much have a different node number to work correctly.
1. Control must be in Manual Mode. Refer to How to Enter the
Manual Mode.
2. Press the NORMAL 40 (∧) or the DELICATES COLD (∨)
keypad until Prog appears in the display. Press the START
(enter) keypad, and AtS 1 will appear in the display.
3. Press the NORMAL 40 (∧) or the DELICATES COLD (∨)
keypad to scroll through the programmable options until
nodE appears in the display.
4.
When nodE appears in the display, press the START (enter)
keypad. The current Network Node Number status will appear
in the display.
5. Press the NORMAL 40 (∧) or the DELICATES COLD (∨)
keypad to change the current status.
6. Press the START (enter) keypad when the correct value ap-
pears in the display. The new value is saved and the next op-
tion will appear in the display.
Error Code Programming Error-
This option allows the owner to turn on or turn off certain errors
in the control.
1. Control must be in Manual Mode. Refer to How to Enter the
Manual Mode.
2. Press the NORMAL 40 (∧) or the DELICATES COLD (∨)
keypad until Prog appears in the display. Press the START
(enter) keypad, and AtS 1 will appear in the display.
3. Press the NORMAL 40 (∧) or the DELICATES COLD (∨)
keypad to scroll through the programmable options until Er-
ror- appears in the display.
4.
When Error- appears in the display, press the START (en-
ter) keypad. There are multiple programmable error code pa-
rameters. Refer to Table 5 .
5. Press the NORMAL 40 (∧) or the DELICATES COLD (∨)
keypad to select the desired option.
6. Press the NORMAL 40 (∧) or the DELICATES COLD (∨)
keypad to select error code.
7. Press the START (enter) keypad when the correct code ap-
pears in the display. The current status will appear in the dis-
play.
NOTE: Press the NORMAL 40 (∧) or the DELICATES
COLD (∨) keypad and then the START (enter) keypad
again to choose a specific coin error parameter. Re-
fer to Table 5 .
8. Press the NORMAL 40 (∧ ) or the DELICATES COLD (∨)
keypad to change the status.
9. Press the START (enter) keypad when the correct status ap-
pears in the display. The next Error Code Programming op-
tion will appear in the display.
Error Code Programming Error-
CErr-
Coin Error Parameters Menu
CEr 1
Coin Error - Determines if display will
show error.
CEr 2
Coin Error Penalty - If enabled, coin er-
ror will erase previous coins entered and
reset the vend price.
CEr 3
Vend Header Present Error - If enabled
and coin drop header is unplugged, con-
trol ignores coin inputs.
Table 5 continues...
Programming Control
©
Published by permission of the copyright owner -
DO NOT COPY or TRANSMIT
51 Part No. 805405ENR5
To Next Page
Loading...
