Configuration
Value
Warm Final
Rinse
Warm Rinse
over-rides fill
temperature
for Final Fill
Enables
Warm Rinse
for the last
active Fill
Step in all cy-
cles
Extra Rinse
Steps Agitate
Time
Time Added
to Rinse Sta-
tus Fill and
Agitate Steps
Adds addi-
tional time for
all Agitate
Steps with
their Status
set to Rinse 1
Extra Wash
Steps Agitate
Time
Time Added
to Wash Sta-
tus Fill and
Agitate Steps
Adds addi-
tional time for
all Agitate
Steps with
their Status
set to Wash
Extra Rinse
Modifier #2
Active Steps
Enabled
Turns on all
Cycle Steps
with Active
State set to
Nod 2
Prewash
Modifier #1
Active Steps
Enabled
Turns on all
Cycle Steps
with Active
State set to
Nod 1
15 OFF ON ON ON ON
16 ON OFF OFF OFF OFF
17 ON OFF OFF OFF ON
18 ON OFF OFF ON OFF
19 ON OFF OFF ON ON
20 ON OFF ON OFF OFF
21 ON OFF ON OFF ON
22 ON OFF ON ON OFF
23 ON OFF ON ON ON
24 ON ON OFF OFF OFF
25 ON ON OFF OFF ON
26 ON ON OFF ON OFF
27 ON ON OFF ON ON
28 ON ON ON OFF OFF
29 ON ON ON OFF ON
30 ON ON ON ON OFF
31 ON ON ON ON ON
* Default for Cycle Modifier B Key #1 Option starting Serial No. 1503031611
** Default for Cycle Modifier B Key #1 Option through Serial No. 1503031610
*** Default for Cycle Modifier C Key #2 Option
Table 10
How to Program Cycle Modifier C Key #2 Options
CNP 3
This option allows the owner to select the options that are ena-
bled when the C modifier keypad is active.
1. Control must be in Manual Mode. Refer to How to Enter the
Manual Mode.
2. Press the NORMAL 40 (∧) or the DELICATES COLD (∨)
keypad until Prog appears in the display. Press the START
(enter) keypad, and AtS 1 will appear in the display.
Programming Control
©
Published by permission of the copyright owner -
DO NOT COPY or TRANSMIT
71 Part No. 805405ENR5
To Next Page
Loading...
