2. Press the NORMAL 40 (∧) or the DELICATES COLD (∨)
keypad until Prog appears in the display. Press the START
(enter) keypad, and AtS 1 will appear in the display.
3. Press the NORMAL 40 (∧) or the DELICATES COLD (∨)
keypad to scroll through the programmable options until
CNP- appears in the display.
4.
When CNP- appears in the display, press the START (enter)
keypad.
5. Press the NORMAL 40 (∧) or the DELICATES COLD (∨)
keypad to scroll through the programmable options until CNP
2 appears in the display.
6.
When CNP 2 appears in the display, press the START (enter)
keypad.
NOTE: To go back to the current programmable op-
tion without changing the value, press the DELI-
CATES 30 (<) keypad.
7. Press the NORMAL 40 (∧) or the DELICATES COLD (∨)
keypad to change the configuration value. Refer to the table
below for the value definitions.
8. Press the START (enter) keypad when the correct value ap-
pears in the display. The new value is saved and the next op-
tion will appear in the display.
Each row contains a unique combination of the words “ON” and
“OFF” that indicates if that column’s feature is turned on or off
when the value is entered. Select the desired combination of fea-
tures and enter the number found in the value column.
Configuration
Value
Warm Final
Rinse
Warm Rinse
over-rides fill
temperature
for Final Fill
Enables
Warm Rinse
for the last
active Fill
Step in all cy-
cles
Extra Rinse
Steps Agitate
Time
Time Added
to Rinse Sta-
tus Fill and
Agitate Steps
Adds addi-
tional time for
all Agitate
Steps with
their Status
set to Rinse 1
Extra Wash
Steps Agitate
Time
Time Added
to Wash Sta-
tus Fill and
Agitate Steps
Adds addi-
tional time for
all Agitate
Steps with
their Status
set to Wash
Extra Rinse
Modifier #2
Active Steps
Enabled
Turns on all
Cycle Steps
with Active
State set to
Nod 2
Prewash
Modifier #1
Active Steps
Enabled
Turns on all
Cycle Steps
with Active
State set to
Nod 1
0 OFF OFF OFF OFF OFF
1 * OFF OFF OFF OFF ON
2 ** OFF OFF OFF ON OFF
3 *** OFF OFF OFF ON ON
4 OFF OFF ON OFF OFF
5 OFF OFF ON OFF ON
6 OFF OFF ON ON OFF
7 OFF OFF ON ON ON
8 OFF ON OFF OFF OFF
9 OFF ON OFF OFF ON
10 OFF ON OFF ON OFF
11 OFF ON OFF ON ON
12 OFF ON ON OFF OFF
13 OFF ON ON OFF ON
14 OFF ON ON ON OFF
Table 10 continues...
Programming Control
©
Published by permission of the copyright owner -
DO NOT COPY or TRANSMIT
70 Part No. 805405ENR5
To Next Page
Loading...
