• Manual Mode: Enter by opening the service door for at least 1 second and then closing service door. Then press A and NOR-
MAL 90 keypads at the same time.
• Press the NORMAL 40 or DELICATES COLD keypad to scroll through the Manual Mode options.
• Press the START keypad to enter any sub-menu options.
FLW103R_SVG
"rAPid"
Rapid Advance
"Prog"
Manual Programming
"AUdit"
Manual Read
Audit
"rESEt"
Manual Reset
"diAg"
Diagnostic
Tests
Press the START keypad to
begin Rapid Advance cycle and
to advance through cycle steps.
Press the START keypad to
enter Manual Programming.
Refer to Manual
Programming flowchart.
"CyCLES"
Total machine cycles
"Coin 1"
Total coins #1
"PULSE"
Total start pulses
"Coin 2"
Total coins #2
Press the START keypad to enter
Manual Reset Mode.
Press the START keypad to
enter Diagnostic Tests. Refer to
Diagnostic Tests flowchart.
Press the START (enter)
keypad to read audit.
Press the START (enter)
keypad to read audit.
Press the START (enter)
keypad to read audit.
Press the START (enter)
keypad to read audit.
"rAPCyC"
Total Rapid Advance Cycles
"rCoin1"
Resettable Coin #1 count
"rUnHrs"
Total run hours
Press the START (enter)
keypad to read audit.
Press the START (enter)
keypad to read audit.
Press the START (enter)
keypad to read audit.
"rCoin2"
Resettable Coin #2 count
Press the START (enter)
keypad to read audit.
"rCyCLE"
Resettable Machine Cycle count
Press the START (enter)
keypad to read audit.
Figure 4
Entering the Manual Mode
©
Published by permission of the copyright owner -
DO NOT COPY or TRANSMIT
24 Part No. 805405ENR5
To Next Page
Loading...
