Allied Telesis CentreCOM GS970M Series - Figure 39: Securing the GS970 M;10 Switch to the Wall with the Front Panel Facing up; Figure 40: Securing the GS970 M;10 Switch to the Wall with the Front Panel Facing Right

Chapter : Chapter 2: Installation
66
FIGURE 39. SECURING THE GS970M/10 SWITCH TO THE WALL WITH THE FRONT PANEL FACING UP
FIGURE 40. SECURING THE GS970M/10 SWITCH TO THE WALL WITH THE FRONT PANEL FACING RIGHT
3. Slide the switch between the brackets so that it rests against the
bracket, as shown in the figures above.
4. Go to “Cabling the switch” on page 69.
Bracket position, viewed from above:
Bracket position, viewed from below:
Bracket position, 
viewed from below:
Bracket position, 
viewed from above: