x530L Series Installation Guide for Virtual Chassis Stacking
197
Verifying x530L-
18GHXm
Member Switches
Perform the steps in Table 33 to confirm the configuration of a member
switch.
8 Designate the ports as the stack trunk with the STACKPORT command.
awplus(config-if)# stackport
% Save the config and restart the system for this change to take
effect.
The remaining steps save your changes and reboot the switch.
9 Return to the Global Configuration mode.
awplus(config-if)# exit
10 Return to the Privileged Exec mode.
awplus(config)# exit
11
Save your changes with the WRITE command.
awplus# write
Building configuration ...
[OK]
12 Restart the switch.
awplus# reboot
reboot system? (y/n):
13 Type “Y” for yes.
14 Wait two minutes for the switch to initialize its management software.
15 Go to “Verifying x530L-18GHXm Member Switches,” next.
Table 32. Configuring the x530L-18GHXm Member Switches - Part II (Continued)
Step Description and Command
Table 33. Verifying the x530L-18GHXm Member Switches
Step Description and Command
1 Start a local management session. Refer to “Starting a Local Management Session” on
page 150.
2 Move to the Privileged Exec mode.
awplus> enable
To Next Page
Loading...
Need help?
General
