The CS series has 2 Load Average Results “Load Average” and “Custom Load
Average”. The Load Average Result will calculate the load average over the entire test.
The Custom Load Average Result will need to be configured with a start distance and an end
distance. The Custom Load Average Result will calculate the load average between the two
configured distance points. The Custom Load Average result is useful for peel type tests.
To set up a Custom Load Average result, select “Custom Load Average (CLA)”:
Then press the “Configure” button and this screen will appear:
Then enter in the Start and End Distance for the test and then press “OK” button.
74 CS User Manual
To Next Page
Loading...
