127139 13 2014-07-30 63
Press to exit the Workorder Notes screen.
Select “Scenario
2
” to access the Scenario function.
A Workorder Scenario is displayed.
The calibration set up is shown in a graphic format, and the
active sensor input is marked. The parameters for this setup
are defined in the work order created using the PC program.
Press to exit the Workorder Scenario screen.
Select “Steps
3
” to access the Step function.
A list of Temperature Steps is displayed.
This function shows the pre-defined temperature steps for
the calibration.
Press to exit the Step function and return to the
Workorder Sensors menu.
To Next Page
Loading...
Need help?
General
