Ametek MX30-1 User Manual

User Manual - Rev AV AMETEK Programmable Power
MX Series 250
Number
Message String
Cause
Remedy
executed
with mode of operation such as
programming frequency when in
DC mode.
-201
"Invalid while in local"
Command issued but unit
is not in remote state
Put instrument in remote state
before issuing GPIB
commands.
-203
"Command protected"
Command is locked out
Some commands are supported
by the unit but are locked out
for protection of settings and
are not user accessible.
-210
"Trigger error"
Problem with trigger
system.
Unit could not generate trigger
for transient execution or
measurement.
-211
"Trigger ignored"
Trigger request has been
ignored.
Trigger setup incorrect or unit
was not
armed when trigger
was received. Check transient
system or measurement trigger
system settings.
-213
"Init ignored"
Initialization request has
been ignored
Unit was told to go to armed
state but was unable to do so.
Could be caused by incorrect
transien
t system or
measurement acquisition setup.
-220
"Parameter error"
Parameter not allowed.
Incorrect parameter or
parameter value. Check
programming manual for
allowable parameters
-221
"Setting conflict"
Requested setting conflicts
with other setting in effect.
Check other settings. E.g. trying
to program a DC offset while in
AC mode
-222
"Data out of range"
Parameter data outside of
allowable range.
Check programming manual for
allowable parameter values
-223
"Too much data"
More data received than
expected
Check programming manual for
number of parameters or data
block size
-224
"Illegal parameter
value"
Parameter value is not
supported
Check programming manual for
correct parameters
-226
"Lists not same length"
One or more transient lists
programmed has different
length.
All lists must be of same length
or transient cannot be compiled
and executed.
-241
"Hardware missing"
N/A
N/A
-254
"Media full"
No storage space left to
save settings or data.
Delete other settings or data to
make room.
-255
“Directory full”
Too many waveform
directory entries
Delete one or more waveforms
from waveform memory to
make room.
-256
“File name not found”
Waveform requested not in
directory
Check waveform directory for
waveform names present.
-257
“File name error”
Incorrect filename
Too many or non ASCII
characters used in waveform
file definition.
-283
“Illegal variable name”
Variable name illegal.
Use ASCII characters only
-300
"Device specific error"
Hardware related error
Check hardware for proper

Ametek MX30-1 Specifications

General

Brand	Ametek
Model	MX30-1
Category	Power Supply
Language	English