Need help?Do you have a question about the Ametek CSW5550 and is the answer not in the manual?
General| Output Current | 0-50A |
|---|---|
| Display | LCD |
| Number of Outputs | 1 |
| Line Regulation | 0.01% + 3mV |
| Interface | RS232 |
Explanation of safety symbols used in the manual for hazard identification.
Details on electrical parameters like input power, output voltage, current, and frequency.
Description of status indicator LEDs on the front panel and their meanings.
Details on the required AC input power specifications for the CSW5550.
Step-by-step guide to performing a functional test of the AC source.
Overview of functional areas: circuit breaker, status lights, knob, display, and keypads.
Settings for VOLTAGE, FREQ, VOLT RANGE, and CURR LIMIT.
Readouts for VOLTAGE, CURRENT, FREQUENCY, and POWER.
Selecting parameters (VOLT/CURR) and display modes (TABLE, BAR, TRACE).
Description of VOLT SURGE/SAG, VOLT SWEEP/STEP, FREQ SWEEP/STEP, VOLT/FREQ SWEEP/STEP.
Parameters for setting START phase, GO TO VOLT, DUR SCALE, DURATION, END VOLT, END DELAY, FUNCTION.
Parameters for setting END VOLT, DUR SCALE, DURATION, END DELAY, FUNCTION, REPEAT, EVENT#.
Parameters for setting DURATION, END FREQ, END DELAY, FUNCTION, REPEAT, EVENT#.
Fields for START/ABORT, PAUSE/RESUME, REPEAT#, and CLEAR SEQ.
Parameters for CLIP LEVEL, GROUP, and MODE for waveform selection.
Steps to set output parameters using the PROGRAM screen and two programming methods.
Description of STEP, PULSE, LIST, and FCSWED transient operating modes.
Procedure for programming a timed sequence of voltage pulses.
List of required equipment for performing routine and non-routine calibration.
Procedure for calibrating voltage measurements in AC and DC modes.
Overview of troubleshooting procedures and the two sections of the guide.
Causes and solutions for the overload indicator being lit.
Specific causes for distorted output related to load and crest factor.
Table of possible error/status messages, their causes, and remedies.
To Next Page