Ametek MX30-1 User Manual

User Manual – Rev AV AMETEK Programmable Power
MX Series 30
2.6.2 -XV Option Specifications
Consult factory for -XV option specifications.
2.6.3 -HF Option Specifications
The -HF option extends the maximum available output frequency from 819 Hz to 905 Hz. Some
restrictions are in effect at this increased output frequency level.
All other specifications of the MX45 system remain unchanged if this option is installed except as
noted in the table below.
-HF Option:
Frequency
Range:
-HF option: 16 Hz - 905 Hz
Resolution:
0.01 Hz < from 16.00 to 81.92 Hz
0.1 Hz
> from 82.0 to 819.2 Hz
1 Hz
> from 820 to 905 Hz
Accuracy:
± 0.01 %
±0.15 % for
–FC option
Phase
Accuracy:
16 - 100 Hz: < 1.5°
100
- 500 Hz: < 2°
500
– 819 Hz: < 4°
81
9 – 905 Hz: < 5°
Voltage
High Voltage Range
Maximum voltage at 905 Hz is 290 Vrms
Maximum frequency at 300 Vrms is 875 Hz
See
Figure 2-10
Low Voltage Range
Maximum voltage at 905 Hz is 145 Vrms
Maximum frequency
at 150 Vrms is 875 Hz
See
Figure 2-11.
-HV Voltage Range
Maximum voltage at 905 Hz is 386 Vrms
Maximum frequency at 400 Vrms is 875 Hz .
Note: If the voltage or frequency settings shown here are exceeded for
any length of time (> 1 sec), the MX may shut down generating an over
temperature fault to protect itself.

Ametek MX30-1 Specifications

General

Brand	Ametek
Model	MX30-1
Category	Power Supply
Language	English