100 ASC110/ASC130/ASC150/ASC200/ASC250
2.7. Controlling and operation of the machine
((
((
(
A
B
AA
B
B
2
3
1
Lifting bonnet
• Move the lever to A position - (lifting).
• Insert the lever to the pump and lift the driver’s stand.
• Move the lever to B position (lowering) and pump with
the manual hydro-generator.
Lifting and lowering using electric-hydraulic pump (op-
tional)
• Remove nuts of the driver’s stand.
• Connect electric system by turning the battery discon-
nector (1).
• Press and hold button (2) (lifting driver’s stand) or
button (3) (lifting bonnet) in ”A” position. Press and
hold appropriate button in ”B” position to perform
lowering.
Screw the driver’s stand in after
lowering. If the driver’s stand is not
screwed in properly, the machine
may overturn and cause lethal
injuries.
To Next Page
Loading...
