Ammann ASC 70 - Page 147

143ASC70
396265C
MAINTENANCE MANUAL
The alternative way of lling the hydraulic
circuit is only emergency solution!
In this way of lling it is necessary to cut
the next exchange interval to one half, i.e.
1000 h or 1 year.
The cap of the tank ller is sealed. In case
of breaking the seal during warranty pe-
riod, the warranty expires.
Observe cleanliness at work. Avoid con-
tamination of the system with materials
that may cause damage to crucial units!
DoNOT open hydraulic tank uselessly!
When cleaning the tank, use cleaners
with no bre-slip, do not use chemical
detergents.
Rell oil according to par. 3.2.4.
Checking the oil thermometer sensor
• Dismantle the sensor and clean the contact.
• Dip the sensor into warm oil of known temperature and
read out the oil temperature on the thermometer. Replace
the sensor if not working properly.
Temperature sensor
Order number: 4-5503580072
Alternative lling through the tank ller
• Rell the tank through the ller with specied type of oil up
to the bottom of the strainer in the ller.
NOTE
When lling via tank ller neck alarge portion of used oil incl.
dirt will remain within the vicinity, and hydraulic units’ life cycle
will lower.
Breather lter
Order number: 1405919