Ammann ASC 70 - Page 45

41ASC70
6
4
5
2
7
3
1
396005
MAX
0
1
2
8
396006
396006A
OPERATION MANUAL
Driver’s seat
Seat adjustment:
1 Backrest position
2 Arm rest position and folding
3 Seat swivel
4 Seat sliding (shift)
5 Seat squab sliding (shift)
6 Seat cushion stiness as per Driver weight indicator
7 Seat height - please, grasp underneath seat squab and
lift slowly to adjust seat height to next higher position,
0 ÷ MAX, which will be locked (it clicks). When lifted to
highest position the seat will drop again to lowest posi-
tion.
Adjust your seat and fasten your seat belt
before driving o!
Document compartment
A document compartment is located on the rear
side of the seat back.
2428
8 Lumbar bolster
! CAUTION !
If Driver stands up from the seat while driving the
speed will slow down until Roller is fully stopped
and braked, this will last 4 seconds. Following next
4 sec. the engine shuts down.
To start the engine again the Driver must sit down
again, shift the travel actuator to neutral, turn ON
brake switch, turn ignition key to “0” position and
then start the engine. Driver must brake o before
starting to move.
If Driver sits down again before 4 sec. have elap-
sed, then the Roller will continue driving at a speed
selected.
If Driver sits down after 4 sec. have elapsed, then the
engine will shut down, the Driver may start moving
it again. Before that the Drives must shift the con-
troller to neutral, and select again the original dri-
ving direction.