5-12 E1 Analyzer Verification, Option 52 Option Verification
5-62 PN: 10580-00255 Rev. J MT8212E and MT8213E MM
25. Verify that the measured peak-to-peak voltage is between 5.4 volts and 6.6 volts.
26. On the T3450 Test Fixture, disconnect the Bantam plug end of the cable from the Oscilloscope.
27. Connect the Receive Bantam plug of the Bantam “Y” Plug of the RJ48 cable to the open jack of the T3450
Test Fixture.
28. On the MT821xE, press the Measurements main menu key and press Rx Signal.
29. Press the Start/Stop main menu key to turn measurement On (“Measure ON” appears in the lower-left
corner of the display).
30. Read the Vpp value from the displayed table and record it in the 120 ohm row of Table A-58.
To Next Page
Loading...
Need help?
General
