Anritsu Spectrum Master MS2720T - Coverage Mapping (Option 431); Introduction; General Measurement Setups; Spectrum Analysis Settings

Spectrum Analyzer MG PN: 10580-00349 Rev. H 6-1
Chapter 6 — Coverage Mapping
(Option 431)
6-1 Introduction
Coverage Mapping Option 431 allows users to map RSSI and ACPR measurements. The
Anritsu easyMap Tools program creates special maps compatible with Anritsu handheld
spectrum analyzers. The software creates files with or without GPS information. The files
will have a .map extension. easyMap Tools is available from the Anritsu website
(www.anritsu.com).
The Coverage Mapping option is suitable for both indoor and outdoor mapping.
6-2 General Measurement Setups
Please refer to your instrument User Guide for selecting the Spectrum Analysis mode, setting
up frequency, span, amplitude, GPS, limit lines, markers, and file management.
6-3 Spectrum Analysis Settings
Refer to Chapter 2, “Spectrum Analyzer” for details and full menu overview of Spectrum
Analysis measurements including bandwidth parameters, sweep settings, trigger types,
attenuator options, and preamp settings.
This chapter presents brief examples and menu overview of Coverage Mapping. Press
Shift + Measure (4) key followed by the Coverage Mapping submenu key.
Note
Set the instrument to Spectrum Analyzer mode for Coverage Mapping
measurements described in this chapter.
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com