TD-SCDMA/HSPA+ Signal Analyzer 4-12 Sweep Menu
3GPP MG PN: 10580-00234 Rev. T 4-27
4-12 Sweep Menu
Key Sequence: Shift > Sweep (3) key
4-13 Measure Menu
Displays the “Measurements Menu” on page 4-21.
4-14 Trace Menu
This menu is not available in TD-SCDMA/HSPA+ measurement mode.
4-15 Limit Menu
This menu is not available in TD-SCDMA/HSPA+ measurement mode.
4-16 Other Menus
Preset, File, Mode and System are described in the User Guide.
Sweep Hold/Run: Press this submenu key to toggle between Run mode
and Hold mode. Hold mode prevents the instrument from taking any new
measurements and freezes the current measurement. Run mode allows the
instrument to continually take measurements.
Trigger Sweep: Pressing this submenu key causes the instrument to make
a single sweep when the instrument is in single sweep mode. This key has
no function when the instrument is in continuous sweep mode.
Figure 4-26. TD-SCDMA/HSPA+ Sweep Menu
Sweep
Trigger
Sweep
Sweep
Hold Run
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com
To Next Page
Loading...
Need help?
General
