3GPP2 MG PN: 10580-00235 Rev. D A-1
Appendix A — Error Messages
A-1 Introduction
This Appendix provides a list of 3GPP2 error messages. Self Test and General Operation
error messages are in the User Guide.
A-2 CDMA and EVDO Messages
Warning Messages
“No trigger found”
This message is displayed if the PN trigger is setup for External or GPS, and the
software does not detect a trigger. Most measurement results that depend on a trigger
are then cleared ('--' is seen in the result area).
“Short Code not found”
This message is displayed if no dominant PN short code is found in the input signal.
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com
To Next Page
Loading...
