be used to generate a service request when the bit value = 1.
*SRE?
Queries the Service Request enable register. Returns the decimal value of
binary-weighted sum of bits.
*PSC {1|0}
Sets the power-on status clear bit. When set to 1 the Standard Event Enable
register and Status Byte Enable registers will be cleared when power is turned
ON. 0 setting indicates the Enable registers will be loaded with Enable register
masks from non-volatile memory at power ON.
*PSC?
Queries the power-on status clear setting. Returns 0 or 1.
To Next Page
Loading...
Need help?
General
