Phase Set = indicates the Phase Setting mode for operating two instruments in a
master-slave configuration.
Phase Setting Mode: indicates the Phase Setting mode that can be programmed
into the instrument.
The Phase Setting Modes available are L1-N and L2-N (two interconnected
instruments) or L1-N, L2-N and L3-N (three interconnected instruments). Press
the Change soft key to toggle the mode. To save the parameter, press the Enter
soft key. To cancel the editing of the Phase Setting Mode, press the Esc soft key.
When the Enter soft key is pressed the Phase Setting Mode is accepted and you
transition into the next system parameter: Function.
If you wish to bypass editing this parameter and move to the next parameter you
can press the Prev or Next soft key.
4.7 Reviewing Test Results
To review the testing results press the Result soft key in the set screen. You may
have to use the <more> soft key to get to the Results soft key. The screen will
look as follows when you are in the correct screen:
Press the Result soft key to view the results. The screen will look as follows:
To Next Page
Loading...
Need help?
General
