4.3.2 Editing Out Mode
Use the , soft keys to navigate to the Out Mode parameter. Pressing the Edit
soft key will provide the following screen:
Out Mode = indicates the instrument is configured to output AC or DC voltage.
Output Mode: indicates the output mode that can be programmed into the
instrument.
Press the Change soft key to toggle the Out Mode to AC or DC. To save the
parameter, press the Enter soft key. To cancel the editing of the Out Mode, press
the Esc soft key. When the Enter soft key is pressed the Out Mode is accepted
and you transition into the next system parameter: Single Step.
4.3.3 Editing Single Step (PROGRAM Mode only)
Use the , soft keys to navigate to the Single Step parameter. Pressing the
Edit soft key will provide the following screen:
Single Step = indicates the status of the single step mode that is programmed
into the instrument.
Single Step Mode: indicates the single step mode that can be programmed into
the instrument.
Press the Change soft key to toggle the Single Step Mode to ON/OFF. To save
To Next Page
Loading...
Need help?
General
