case, the key lockout on the front panel is enabled by pressing the Lock button.
If the password has been set to anything but 0, a password entry pop-up screen
will appear to access the Lock and Mem Lock parameters as well as key lockout
on the front panel of the unit. The password default is preset to 0 at the factory.
Forgotten Password
If you have forgotten your password, a new password should be entered or enter
“0” to disable the password. The old password cannot be recovered.
Secure Lock and Mem Lock Access
If a password has been created, when you press the Lock or Mem Lock soft key
or the key lockout on the front panel, a password pop-up screen will appear. The
pop-up message will appear as follows:
In order for you to access the Lock or Mem Lock parameters, you will now have
to enter the proper password. If you have forgotten the password, please refer to
the Forgotten Password instructions in the Security section.
4.1.3 Lock
From the Set screen press the <more> soft key. Press the System soft key.
Highlight the Lock parameter using the , soft keys. When the Lock
parameter is highlighted, you may turn the function ON and OFF by pressing the
Change soft key. Press the Enter key to accept the new setting or the Esc key to
cancel and return to the original setting. When the Enter key is pressed, the new
security setting will take immediate effect.
Selecting Lock “ON” restricts access to parameter and system settings. The
level of security is determined by the Mem Lock function.
4.1.4 Mem Lock
From the Set screen press the <more> soft key. Press the System soft key.
To Next Page
Loading...
Need help?
General
