Contrast = indicates the status of the contrast setting that is programmed into the
instrument.
Contrast Range: indicates the contrast range that can be programmed into the
instrument.
Use the numeric keypad to enter in the contrast. The ranges available are 1 – 9,
where 9 is the highest contrast or the darkest. Press the Enter soft key to accept
the parameter. To cancel the editing of contrast setting, press the Esc soft key.
To move to the next system parameter for editing, press the Next or Prev soft key.
The Exit soft key is also available to return to the System parameter screen.
When the Enter soft key is pressed the Contrast is accepted and you transition
into the next system parameter: Power Up.
4.3.6 Editing Power Up
Use the , soft keys to navigate to the Power Up parameter. Pressing the Edit
soft key will provide the following screen:
Power UP = indicates the power up mode that is programmed into the instrument.
Power UP Mode: indicates the power up mode that can be programmed into the
instrument.
The power up modes available are ON, OFF or LAST. In the ON mode output
will be supplied on power up of the instrument. In the OFF mode output will NOT
be supplied on power up of the instrument. In the LAST mode output will be
supplied according to the last state the instrument was in prior to power off.
Press the Change soft key to toggle the Power UP Mode to ON/OFF/LAST. To
save the parameter, press the Enter soft key. To cancel the editing of the Power
Up feature press the Esc soft key. When the Enter soft key is pressed the
Power Up parameter is accepted and you transition into the next system
parameter.
To Next Page
Loading...
Need help?
General
