4.6.26 Editing Connect
Use the , soft keys to navigate to the Connect parameter. Pressing the Edit
soft key will provide the following screen:
Connect = indicates the status of the connect mode that is programmed into the
instrument.
Step Connect Mode: indicates the connect mode that can be programmed into
the instrument.
Press the Change soft key to toggle the connect mode ON/OFF. To save the
parameter, press the Enter soft key. To cancel the editing of the step mode press
the Esc soft key. When the Enter soft key is pressed the connect mode is
accepted and you transition into the next parameter: Memory Cycle.
If you wish to bypass editing this parameter and move to the next parameter you
can press the Prev or Next soft key.
When the connect mode is ON there will be an underscore _ next to the step
number in the set screen. It will look as follows:
4.6.27 Editing Phase Set (Option 08 – PROGRAM Mode only)
Use the , soft keys to navigate to the Phase Set parameter. Pressing the Edit
soft key will provide the following screen:
To Next Page
Loading...
Need help?
General
