Delay = indicates the delay time that is programmed into the instrument.
Delay Time Range: indicates the delay time range that can be programmed into
the instrument.
To change the delay time, use the numeric keypad and type the time. Once you
type in a number a shaded black box (■) will begin blinking acknowledging the
parameter is being changed. Press the Enter soft key to accept the time, or
press the Esc soft key to move back to the Delay Time Parameter screen. When
the Enter soft key is pressed, the time is accepted and you transition into the next
parameter: Dwell.
If you wish to bypass editing this parameter and move to the next parameter you
can press the Prev or Next soft key.
4.6.15 Editing Dwell (PROGRAM Mode only)
Use the , soft keys to navigate to the Dwell parameter. Pressing the Edit soft
key will provide the following screen:
Dwell = indicates the dwell time that is programmed into the instrument.
Dwell Time Range: indicates the dwell time range that can be programmed into
the instrument.
To change the dwell time, use the numeric keypad and type the time. Once you
To Next Page
Loading...
Need help?
General
