11.4.6 IP Address
Highlight the IP Address parameter using the , soft keys. When the IP
Address parameter is highlighted, press the Edit soft key.
A specific IP Address must be entered into this field if the IP Setup parameter is
configured to MANUAL. Enter the IP Address that you wish using the numeric
keypad. The IP Address must be entered in the following format:
XXX.XXX.XXX.XXX. A valid IP Address must be entered. Users may not use the
following IP Addresses:
255.255.255.255
000.000.000.000
Enter the preceding IP Addresses will cause the following error message to be
displayed:
Press the Exit soft key to save the new settings. If the IP Setup parameter is set
to AUTO, you do not need to enter an IP Address manually.
11.4.7 Gateway IP
Highlight the Gateway IP parameter using the , soft keys. When the
Gateway IP parameter is highlighted, press the Edit soft key.
A specific Gateway IP must be entered into this field if the IP Setup parameter is
configured to MANUAL. Enter the Gateway IP using the numeric keypad. The
Gateway IP must be entered in the following format: XXX.XXX.XXX.XXX.
Press the Enter soft key to save the new settings. If the IP Setup parameter is set
to AUTO, you do not need to enter a Gateway IP manually.
11.4.8 Subnet Mask
Highlight the Subnet Mask parameter using the , soft keys. When the
Subnet Mask parameter is highlighted, press the Edit soft key.
To Next Page
Loading...
Need help?
General
