To Next Page

To Previous Page

Use the ,  soft keys to navigate through the System parameters. Press the

Edit soft key to select the parameter. The parameter will be highlighted black if it

is available for editing. Press the Edit soft key to open up the system parameter

for editing. The Exit soft key will return you back to the set screen. If you open

any System parameter screen you can navigate through the System parameters

by using the Prev and Next soft keys.

4.3.1 Editing Auto Run Mode

Use the ,  soft keys to navigate to the Auto Run parameter. Pressing the Edit

soft key will provide the following screen:

Auto Run = indicates the status of the run mode that is programmed into the

instrument.

Auto Run Mode: indicates the run mode that can be programmed into the

instrument.

Press the Change soft key to toggle the Auto Run Mode to PROGRAM/MANUAL.

To save the parameter, press the Enter soft key. To cancel the editing of the Auto

Run Mode, press the Esc soft key. When the Enter soft key is pressed the Auto

Run Mode is accepted and you transition into the next system parameter: Out

Mode.

APT 300XAC Series User Manual

Other manuals for APT 300XAC Series