Wheels, Axles & Chains Argo Service Manual
WA-8
CAUTION
Do not use regular oil or grease to lubricate the idler chains. Regular oil or grease will
be thrown o the idler chains during normal operation, and contaminate the brake pads
or discs. When these components become contaminated, brake eectiveness can be
compromised or complete brake failure can occur.
Regular maintenance of the drive chains is essential to both good vehicle performance
and personal safety. Poorly maintained chains can result in rusted, corroded or seized up
chains, damaged sprockets, damaged frame, and costly repair bills.
1. Every 25 hours of vehicle operation perform the servicing procedure, Drive Chain
Inspection.
2. Every 10 hours of vehicle operation perform the servicing procedure, Drive Chain
Take-Up System Inspection.
3. Every 10 hours of vehicle operation perform the servicing procedure, Drive Chain
Lubrication.
4. Every 100 hours of vehicle operation perform the following servicing proce-
dures:
• Drive Chain Inspection
• Chain tensioner Inspection
Outer Axle Flange & Bearing Lubrication
CAUTION
Do Not Use High Pressure Pneumatic Greasing Equipment
Outer Axle Bearing Lubrication
Each outer axle ange is equipped with
one grease nipple. This grease nipple
supplies grease directly to the outer axle
bearing . It also requires re-greasing every
25 hours of operation or before the vehicle
is taken out of service for any extended
period. Use a pistol grip type grease gun to
avoid dislocating the bearing seals due to
excessive grease pressure.
See NOTE following page.
To Next Page